Browse Forums Windows & Doors Re: Safety strip with logo on glass 32Jun 28, 2012 3:42 pm For info on our build: viewtopic.php?f=31&t=43093 Built the McLaren by Dechellis - slab down 22 Feb - handover 30 Aug 2011 - and gardens finished 9 Dec 2012!! Re: Safety strip with logo on glass 33Jun 28, 2012 4:51 pm ed @ ecoclassic Yes, I agree... I am sure you can peel off the middle bit and get a glue remover to clean it up... Ed What Ed said. Just get a razor blade to scrap off the middle logo and then use eucalyptus oil to remove any residue. Anyway, I'm sure I'm not the only one who thinks you have made a mountain out of a molehill.. Take a photo from 2m away, I'm sure it's not that bad... You must be lucky with your build if this 'issue' has got you so worked up..lol Re: Safety strip with logo on glass 34Jun 29, 2012 2:37 pm Take extra care... you should not use a blade on a toughened glass panel, like this door, because toughened glass carries "fines" embedded in the surface, which can be picked up on a blade and scratch the glass... so be gentle... Ed "ECOECO" At 'EcoEco', we design windows, we design the best windows, we do it for you, so that when you’re happy we are happy. Tel. 1800 326 326 Hi everyone. I am a single mother with little daughter, living in a small tourist town in WA Australia. I am thinking to install security screens to all the doors and… 0 37371 Hi everyone, Just wondering if anyone has switched from a small square tile insert or normal square waste to a strip drain at all, and if so did the plumber or diy-er… 0 13415 |