Browse Forums Flooring & Floor Covering Re: Preparing/Cleaning concrete slab 20Jun 14, 2007 3:08 pm Yak_Chat If you're going to patch the hole, you will most likely need to use some bondcrete or similar (Which makes the new concrete stick to the old) and then mix up a small amount of very fine sand and cement to make a paste to fill the hole. As for matching colours, well that will be very tricky. Options are to make a feature of it by say painting a mural over this area before you seal it or similar. If you go to a good hardware store and tell them your problem they will be able to advise what to do. Steve Damn that sounds hardcore... I'm lazy, I was hoping to get something like <non existant product>"Selleys Concrete in a Tube"</non existant product>, just squeeze some in and then scrape off the excess Anyway, I'll see what they say at the hardware store as suggested. Cheers. No, I even have sections of narrowness where the tiles won't slide up any further. When I manage some spare time, I might play around with the first DIY part of my… 7 5290 The concreter will take and reuse. In my case I bought structural LVLs and scraped them back and used them as joists. 1 5841 yep, clearly mark where the infloor heating pipes are before drilling or nailing 1 6347 |