Browse Forums Kitchen Corner Re: Support for Granite bench sink cutout 5Feb 10, 2014 6:22 am Cutting Edge Kitchens and Cabinet Making http://cuttingedgekitchens.net.au http://www.facebook.com/pages/Cutting-Edge-Kitchens/290484196676 Mobile : 0419 430 575 PH: 9452 4772 Fax :9452 4772 cuttingedgekitchens@outlook.com Re: Support for Granite bench sink cutout 6Feb 10, 2014 8:48 am Unless you are a stone mason I would not attempt cutting a sink hole out. There are parts that are quite narrow round a sink and it could be an "oh Sh!T" moment. I thought the holes are cut out first to be honest. Cheers Mark Re: Support for Granite bench sink cutout 7Feb 10, 2014 9:12 am Yes we were aware there would be a big mess - thats ok. Not being stone masons, and not wanting to risk it breaking while we were moving it and possibly getting the measurements slightly wrong we decided to do it this way - and now thats what we have to work with. This is also the way they did the marble vanities in our bathrooms - installed the stone, then cut the holes for the sink and plumbing. Smaller cuts, so less dust, but same principle. I think we're leaning towards undermount now anyway though... Re: Support for Granite bench sink cutout 8Feb 10, 2014 11:06 am saxlady I think we're leaning towards undermount now anyway though... An under mount is a whole different kettle of fish!! The cut needs to be very precise and then needs to be fully polished! Most under mount bowl cut outs are done on a CNC machine in a factory! Cutting Edge Kitchens and Cabinet Making http://cuttingedgekitchens.net.au http://www.facebook.com/pages/Cutting-Edge-Kitchens/290484196676 Mobile : 0419 430 575 PH: 9452 4772 Fax :9452 4772 cuttingedgekitchens@outlook.com Re: Support for Granite bench sink cutout 9Feb 10, 2014 11:52 am can't see that the hole for an undermount sink will be perfect the way you intend to do it. The cut has to be accurate and polished. Stonemasons charge more for it than a simple cutout for a countertop sink. Think carefully that you are not disappointed with the result later. As CEK said, a neat and proper cut would normally be done by a machine. 4 4474 0 12342 I'd try posting it on airtasker. I am sure you will find someone willing do take them for a couple of hundred $ 1 399 |