Browse Forums Heating, Cooling & Insulation Re: Brivis NC-6 installer parameter access configuration 5Jun 20, 2016 6:17 pm CD2 I was wondering if someone could help me out with configuring my zone setup. I have lost my zone settings and everything has gone back to default. My system is Brivis ducted heating with add on cooling. Its only 6 months old. Its split into 2 zones, with 2 x NC-6 controllers. Zone A upstairs with a slave controller and Zone B downstairs with the Master controller. Current installer settings are n01 ID00:1 n01 ID01:1 n01 ID02:1 n01 ID03:0 n01 ID15:1 n01 ID16:1 n01 ID17:0 n01 ID43:0 n01 ID73:1 n01 ID92:0 Can someone help me with the above setting to match me configuration that i require? Its split into 2 zones, with 2 x NC-6 controllers. Zone A upstairs with a slave controller and Zone B downstairs with the Master controller. Call Brivis, they can run you through the procedures over the phone. Built: Modified H3nl3y S0h0 Q1 in Melbourne :- Never again For reference, this is the Austlii reference. My take on this is, that they would be breaking the law denying access to a homeowner in Victoria, or their agent from having… 1 10213 The only thing to add to these comments is that where possible it's always good to try and work with people than just say "no" because you can. Having someone… 4 18062 |