Porter Davis homes

what was the colour of your grout? and did they grout the grooves?[/quote]

I actually couldn't tell you the colour if the grout. What's in our contract is incorrect. It was only lucky that the fantastic tiler picked it up. And yes we got them to grout the whole tile so it looks like a mosaic. I was very specific that I wanted them all lined up perfectly and I'm pretty impressed with the outcome. Are you using the same tile?

Best of luck for the others approaching PCIs in the next few weeks! Exciting times ahead!

I actually couldn't tell you the colour if the grout. What's in our contract is incorrect. It was only lucky that the fantastic tiler picked it up. And yes we got them to grout the whole tile so it looks like a mosaic. I was very specific that I wanted them all lined up perfectly and I'm pretty impressed with the outcome. Are you using the same tile?[/quote]

yeah i'm using the exact same tile for the entire wall of a kitchen, i'm concerned about the alignment but i guess you need to have faith that the tiler knows what they are doing. i think our grout is a dark grout, ideally i didnt want the grooves grouted, i like those deep cuts but they have to be done since not sealed

Congratulations!!

Last house PCI took about two and 1/2 hours. (Major geek alert). I did a spreadsheet room by room listing power points, light switches, data points, foxtel points, taps types, floor type, etc as we moved into each room I ticked it all off. We had a night light that we put into every power point to test that it worked (two didn't) Switching lights off and on, Ixltastic fans, light and heat (one heat lamp did not work) taps off and on, check the basins drain, toilets flushed, grout around edges of tiles to walls, checked laminate doors and cupboards for scratches, bench tops for scratches and chips, tested drawer handles, range hood venting, open and shut doors, make sure they close and open smoothly, that you have privacy locks where they are supposed to be, runners for sliding doors, door stops, mirrors, fly screens, sharp pieces of tile where they have cut tiles in the shower or bath etc. also made a list for the garage and outside too.

Yes, I am a geek. We found at the side of the bathroom vanity a big scratch which we would not have seen until we got in the bath, some door stops missing, a fan that did not work, a couple of cupboard doors that did not line up properly when closed, a couple of chipped and cracked bricks, a sliding door that did not go back all the way into the cavity, millions of red dots for paint touch ups, some bad joins in the gutters. Just lots of little things. That's what PCI is for.

I then had a list of everything that was to be fixed so it was easy to walk through at hand over and see that everything had been done.

It's easy in the excitement and impatience of needing / wanting to be in to miss things, but you will be paying for your house for quite a few years, so you need to be dispassionate about it. Remember you are being asked to pay probably between $300-$500k for this house, if it was a car would you accept it with scratches and dings?

Hope that this helps.

I'm using (almost!) the same tile for the splashbacks in the bathroom and ensuite - except we got the tile with the vertical grooves as well. Initially I was worried that they would be too dark. But they look lovely on your wall, Sambogirl so I am happy with the choice we made!!

Hey everyone... can anyone reveal the options for light switches and power plugs? The people from electrical (via email) told me that we can choose Saturn, Slimline or Eclipse range options.

Is this accurate?

Hi ajd, good luck for PCI!

At least if you have 20 pages there will be an end in sight. We are getting close but getting frustrated with all the little fiddle things at the end, probably like everyone else. It makes me so mad that each trade does not care about other trades work, so work has to be redone. Honestly, if all the trades turned up there would be a weeks work max, but it does not happen that way, I am sure it is driving my SS crazy. He thinks trades have been back and they haven't, so other trades can't finish.

Enough of my dramas, I am sure that once we can all sit on the alfresco with a wine or sixteen, the drama will be a distant memory. I can't wait to turn the house into a home and I am sure that most people building feel the same way, PD build the house, we build the home.

Will be sending positive thoughts for you next Friday!

I asked electricals the same question and they only have the one hard wired option. Couldn't even pay more to get the GPO plugged ones which is really insane to me. It's a lose lose. They lose the opportunity to make more money with the upgrade and we lose by getting crapping LEDs and having to redo them later.

It's all outsourced anyway.. you'd think who'ever they outsource the electricals to would know how to install the LEDs with the individual GPO plugs! [/end rant]