Browse Forums Landscape & Garden Design Re: Paving Advice...or getting edgy! 6Oct 16, 2008 10:47 pm Fu Manchu If you are doing a huge area and will be doing a bit at a time I would buy a 9 inch grinder for about $100 and a diamond tip saw blade for about $80 and do it that way. brick saws aren't cheap to hire many times over and so by an alternative instead. Lots of dust though FuMan good advice. I bought a cheap GMC angle grinder for the job at the old place, I worked out I'd need to kill two grinders to break even with renting. Still using the original grinder.... ....although I did look like a Martian with all the red brick dust.... Yeah like I'm not sure about the timber idea... Cheers, Mike I had 28m2 of engineered pavers laid six months back and it was difficult to find someone not taking the pi$$. Internet suggested it should be $85-100/m2 to lay them.… 3 12412 As most others have posted above the install isn't compliant. The pipe is meant to be covered in loose soil or sand, the pipe has holes in it that leaks out a termicide… 10 5730 |