Browse Forums DIY, Home Maintenance & Repair Re: Render cracks 3Jan 18, 2023 8:19 am kplukjan37 I understand clay in Sydney moves a bit but the slab was made accordingly. If cracks are common and just too bad I should have stuck with brick 😕 Hey kplukjan37 Welcome to the forum You will need to monitor the cracks and it would have been a good idea if you took slab levels during construction and had them checked Now the builder will claim they are out of warranty maintenance problems and your landscaping is probably to blame? yes. it would have been better to have stuck with reinforced masonry... Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re: Render cracks 4Jan 18, 2023 8:28 am Thanks for your input arcadelt and structuralBIM guy. I did have an independent inspector review the slab during the build with no concerns raised. I also haven't done any landscaping yet so the yard hasn't been touched since then. Hopefully that might help my argument. Is this common after a few months using Hebel and render ? Do you have a scope of works? If have texture on wall now, the patch will show through The standard for repair of texture is to patch, re-texture corner to corner,… 5 7373 The mesh is often stuck on wall first then rendered over, which means it does nothing Not to specifications Get a scope of works in writing before start, needs to be… 10 9549 It sounds like you have a crack in your garage where the wall meets the ceiling, along the shadow line on the… 0 18001 |