What are the tolerances on straightness of skirts? I think ours are pretty wavy but am I just too picky? My eye can pick the tiniest error so I find it hard to know when I am being reasonable. I am concerned that once the tiles go down that it might be more obvious. It seems to us that the chippy has over tightened the screws (steel frame) causing them to bow in wherever they are fixed?? I have mentioned it to my SS, didn't get much response, if this is considered workman like I'll drop it, and learn not to look down .
Apart from a few small spots the plaster seems to be pretty good, it's just the skirts. The steel frame was inspected and was also straight.
Not easy to see in photos unfortunately, I need a yellow level so the shadows are clearer.
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅