Browse Forums Renovation + Home Improvement Re: Laminate flooring DIY - Advice needed 6Mar 24, 2015 8:56 am Another two questions I have.. 4: Do you undercut cavity sliding door frames the same as you would normal door frames? The reason I ask is because the cavity sliding door jambs seems to have a metal casing. All of the DIY YouTube videos show the undercutting as a few simple cuts and the undercut pieces just popping out easily, so was wondering if it was the sames for all types of frames. 5: What sort of gap should I leave at between the slate tiles in the hallway and the new laminate floor in the main room? I’m guess the height of the existing slate is about the same and the new laminate flooring. Re: Laminate flooring DIY - Advice needed 7Mar 24, 2015 10:28 pm 4: Yes but just the timber part of the jamb. Don't even think about trimming the metal frame! 5: 10mm should be more than enough if the slate is even and the jamb is plumb. Stewie Just about completed a renovation project and hit a small issue that we didn’t see We have laminate floors now where we had tiles before (turned out it was actually 2… 0 5242 DIY, Home Maintenance & Repair At a bit of a loss on this one - we're thinking the original owners never removed the protective laminate covers from their kitchen cabinets after installation and in the… 0 6671 |