Browse Forums Kitchen Corner Re: 'Touch' activated kitchen tapware - in Australia? 9Jun 25, 2014 11:04 pm That's the troubles with the Aus plumbing supply chain, from what I can see. I would guess that most retailers would pay about 35% less then retail for Grohe. So that 40% off is cheaper then the merchants can get it for, before adding their cut! You can thank our higher standards, not supplied directly by manufacturer ( there's a middle man in AUS), costly WELS scheme, transport and cost to run a business here for that! I guess it's also a risk, to have no warranty. Quality is like buying oats. If you want good,fresh oats,you'll pay a fair price. However,if you can be satisfied with the oats that have already been through the horse, that comes a little cheaper. Re: 'Touch' activated kitchen tapware - in Australia? 10Jun 25, 2014 11:33 pm Also don't forget that DR brass is needed which apparently requires a separate tooling setup. I think the whole dr brass is a ploy by certain Aussie Manufacturers to restrict the market. Normally you use builders bog. Polyurethane painting is basically the same principle as car panel beating and painting. All the prep work is the same and so is the… 3 3068 Thank you fro your response, Simeon. It is good to hear that you have had a positive experience with Parisi. I am always on the lookout for reliable products, and personal… 2 4339 If you don't want to annoy the neighbours then simply get yourself some good head phones. For me the sound is much better using headphones. The NCC (National Construction… 1 26168 |