Browse Forums Heating, Cooling & Insulation Re: Adding a second Brivis Networker 8Sep 16, 2008 11:43 am mikemix raff Gday all, I have a Brivis central heating unit in a new house with the Networker (V3) installed to the heater downstairs. I would like to add an additional Networker upstairs and wonder would anyone shed some light on what is involved to set up the controller. I already had a 2 wire power cable running between both the heater and current Networker and the planned location of the new Networker. (Planned ahead at frame stage- just in case!) From the Brivis website I read that 2 controllers can be installed from the one heater running as master/ slave but gives no indication to what is involved in the setup procedure. From looking at the current networker it runs from a two wire setup from the control module on the heater unit itself but doesn't seem to have a terminal for a second controller? Im wondering whether aside from an additonal Networker (which I have) would any other parts be required and if so an estimate for cost of installation? Any info would be appreciated. Cheers The only setup that is require is setting the 2nd networker to be number 2 (slave) - I thik by default they are all set to 1 which is the master. Ring up Brivis and they should be able to talk you through it. I don't have the instructions on me at the moment but can post back this evening - just post a reply and let me know Thanks for the info, I have 'found' some installer notes on the dual installation and it requires connecting the networkers in parallel and then setting one to slave- nothing too complex. Thank for the help guys! Re: Adding a second Brivis Networker 9Oct 26, 2008 11:25 am Does anybody have some notes on how to wire this and how to set one of the networkers to Slave?
HC Re: Adding a second Brivis Networker 10Nov 20, 2008 2:09 pm Sorry to steal the thread. But how much is it to add a Networker Controller? \/\/\/\/\/\/\/\/\/ Re: Adding a second Brivis Networker 11Nov 20, 2008 2:16 pm Sorry, I got my extra Networker with the install, so I don't know.
HC Re: Adding a second Brivis Networker 12Jan 13, 2009 2:37 pm The second networkwer is normally the slave is useful when you have 2 zones .When heating second zone only ie Bedrooms second controller is usally in the master room so it can turn unit off when at rerquire temp.With a single controller in the middle of house it takes a lot longer for temp to travel from rooms to main area resulting in bedrooms running up to 5-6 degrees hotter than set point.
Speak to Brivis they should sent out paper work to wire We were lucky in that our old house was so small (86 square metres) compared to the new house, they were able to take enough readings around the old backyard house before… 8 37267 Hi, We have a single story MacDonald Jones house, on a waffle pod slab with steel frame. Are we able to build a second story extension? Other info is we are 900mm from… 0 8530 We are building a second dwelling and are currently selecting window and door frames. We want to blend into the forest and also bring out the stone work and the fake wood… 0 16327 |