Browse Forums Lighting + Lighting Design Re: Exterior lighting help 4Jan 23, 2018 7:33 pm You can have a sensor that is in the circuit but seperate from the lights. That way, you can not only choose the lights you want, but position the sensor in a place that might be better than adjacent to the light. They even make sensors that are mechs that fit into light switch plates. Building Standards; Getting It Right! 1. optional, you can but normally just use the earth from the main switch board 2. should be enough but the distance determines voltage drop - sparky should work it… 1 22073 I have a really long hallway which is 1100mm W x 11500mm L I would appreciate if anyone can give suggestions to light it up with Linear LED lights that goes from wall to… 0 5591 What? It's a lighting question, the control joint is only needed at 12m centres, a bulkhead or change of direction will suffice as a 'break' in the ceiling, just make… 8 5861 |