Browse Forums Lighting + Lighting Design Re: multi globe ceiling lights 8Jan 06, 2014 3:39 pm Hi, Sounds like it could also be a surging problem. I'm an electrician by trade, and work at golights.com.au and I have encountered these issues a few times with our customers, and I can say that every case is unique. Surging may be a problem, especially if the installation is quite old. I noticed that your installation was done in the 80's? It might be a good idea to have an electrician check the wiring, and for any possible surges. Another case may be a faulty batch of globes. But of course, that should be ruled out once the globes are changed, and if they blow again. You mentioned the fittings were ok? If so, please check the wiring. Without having seen your wiring, I would assume this is the first place you start. Some Lights will have a minimum wattage and a maximum wattage. Again, not having seen your lights, as long as you are meeting these requirements, it should not be an issue. Kind Regards, Kristin Lighting Expert Phone -1300 798 220 Email - service@golights.com.au Website - http://www.golights.com.au So I'm just reading up on this ecosystem of lights. I'm planning on putting deck lights along the outside edge of a large deck. Will need about 3 packs (18 lights) plus… 0 23021 Unless the room is for storage then it's non compliant BCA V2 2019 S3 P3.8 You have 2 options 1. The builder deconstructs the section and rebuilds as per plan /… 7 10684 How do you remove one of these ceiling air con vents? And is it possible to disconnect the duct joined to the vent from inside the house, without going into the roof cavity? 0 5933 |