So I'm just reading up on this ecosystem of lights.
I'm planning on putting deck lights along the outside edge of a large deck. Will need about 3 packs (18 lights) plus one more for a step.
Seems each pack comes with an 'end light' where nothing can be connected further.
Is there a way to just have one continuous chain of lights without leaving out a couple end lights and then being short?
Hope that makes sense, TIA
WatchingStarredHistory
MembersPros
Browse Forums Lighting + Lighting Design legit in every lighting shop and even bunnings. There's like hundreds of different models. a google would return you about 1,023,283 results 2 8802 Those span tables can be pushed a little for a low deck if you dont mind a little flex. Last deck I did, I pushed it a little and it was still rock solid - no noticeable… 6 24027 1. Depth gauge, wrap duct tape where you wish to terminate your drilling onto the drill bit and use your eyes throughout performing. 2. 2 vs' 4, most at bunnings will… 2 7708 |
