Building Forum›Flooring & Floor Covering

Patching Tas oak floorboards

Page 1 of 1

Jan 31, 2019
8:34 pm

Hi all

Just purchased a 1960s house with Tas oak hardwood floorboards, however in the lounge area the old fireplace was removed and the mantel area poured in with concrete instead of patching with floorboards

I want to jack the concrete out, put some joists in and patch with new/old floorboards. I assume the patch will stick out, so what's everyone's thoughts on this? Any tips?

Cheers!

Ashington Homes

2/02/2024

Patching Holes in EPS foam walls

Renovation + Home Improvement

Oh no! I would use a can of expandable foam ( there are some that will take render) then cut it back and render over the top

newbie85

4/12/2023

Miners Cottage floorboards

Flooring & Floor Covering

Hi All New to the forum and looking for some advice, has anyone else renovated an old miners cottage in or around Ballarat and been able to identify the flooring? We…

firsthyme

24/04/2024

Ensure rubber gym floor is flush to floorboards in hallway?

Flooring & Floor Covering

Hi there, looking to have a gym in a new build. Planning to install some sort of rubber mat flooring (on concrete) i.e. Asking the builder to not do floorboards in the gym…