Browse Forums Pools & Spas Re: Help with New Pool Setup 12Feb 12, 2013 2:22 am wheeliworks No air should be in the system. If air gets into the system it means you have a suction problem between skimmer box & pump the most common cause is either the o- ring on the inlet of pump or the seal on the lid when the pump is off does the water drain beck to the pool ? Since I redid the majority of the connections after the paving and pool shed installation, air ingress is no longer a problem like it used to be Seems that when you push flow below the min for cell you get the air/gas build up issue (thread on it over at whirlpool). wheeliworks If you are salty when getting out of the pool you probably have too much salt in the water. . You should only have a very very slight taste if you tasted it Personal preference, all things being equal in an ideal world I like fresh water (obviously chlorined dosed), the salt water has been a good compromise after my chemigem experience (my salt is 3200ppm according to pool shop). The last home I lived in didn't have a pool and when i went to sell it the agents were not happy, even telling me to put one in to sell the place. The agents weren't happy… 2 2558 In addition to protecting your children, glass pool fencing has the benefit of being simple to clean and maintain. You probably won't need anything more expensive or… 0 3038 Hi everyone, Looking for some advise. We are about to build an above ground pool in our backyard. There is a private sewer line running under the pool at 1.6m… 0 7642 |