Browse Forums Laundry Re: Help - Laundry bench height too low for front loader 8May 20, 2011 9:50 am Good point..... the builder had to let the cabinet maker into the house to measure? personally? and didn't bother to mention the floor and the cabinet maker didn't think to ask whether the floor would need screeding A tiler who nearly did our house was going to screed our kitchen/lounge/dining and hallway which is on the top level, he said it was the only way to get the floor level. I said, sorry but if you do that it will put the level of the floor up the skirting and the kickboard in the kitchen ...and there was no way that was happening. He wouldn't do it any other way. Fortunately for us he couldn't start when we wanted him to and we found another brilliant tiler, obviously with more experience than him. New tiler didn't even mention screeding, and the tiling job is fantastic. If we hadn't discussed it, and he had just gone ahead doing it his way, I would have been moritifed If I have learnt anything with building, it's to ask about every.....little.....thing. Sorry su ann it doesn't help you, just a story about communication I guess. Maybe if you put a bit more pressure on the builder he would go halves in fixing it properly. Thanks! I'm spoke to the builder I'm not sure if this is all true but basically went along the lines of they considered all options and if I was to compact and fill it… 2 7300 The requirement is for a waterstop to be installed to the entries of the room, (a small aluminum 'L' angle to retain the water to within the room) can't see if they have… 1 1938 This is a very tight fit, I'm not sure if you'll be able to achieve what you've described. Would you consider accessing the separate toilet from the laundry? If so maybe… 1 11252 |