Browse Forums Renovation + Home Improvement 1 Jun 24, 2018 2:54 pm Hi, We are going to replace one of the external walls in our existing house - built in a Flamezone - with a new wall. The existing wall has a massive floor to ceiling window in it and we want to replace it with a wall with a much smaller window. We will build a new studded wall with the new window built in. To cover the rest of the wall, we need to find external cladding that we can use on the outside that suits a Flame zone area. Does anyone have any suggestions to what we could use here? Thank you. Re: FlameZone cladding? 2Jun 25, 2018 6:20 am Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re my second point – yes exactly. And often it may take additional time if the manufacturer recommends no more than X meters… 3 6295 Hi, Currently building, we are on a sloping block so we have from floor level to the roof in axon cladding. Below floor level to the ground I want to put brick facings /… 0 4876 The most definitive answer to your question James is this taken from the James Hardie Axon Cladding Installation Guide - i just happen to have it… 5 4110 |