Browse Forums Renovation + Home Improvement 1 Nov 01, 2017 8:27 pm hello, im new here, me and my partner are looking to add a bbq area comming off the back of our house. the house is a brick vaneer, hardwood framed house built in 1991. these are the plans i have come up with: Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ we are looking to attach it to the house with these brackets: Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ from bunnings https://www.bunnings.com.au/dunnings-22 ... s%2fdetail (have not measured the pitch of the existing roof yet so pay no attention to the angle of the bracket.) they go through the facia and bolt to the rafters of the house, you then bolt a ledger to them. i will be putting some tinted laser-light on top(with a gutter and downpipe). do my plans look adequate? I got all my timber sizing and spacing from: http://www.hyne.com.au/documents/Featur ... _final.pdf also i am not sure of how many of those brackets i will need. the bbq area will be just under 6m wide. Thanks for any advice or comments. I'm using the 5 burner version of this BBQ in black. The beefeaters are a well known and reliable brand. They integrate well with the cabinetry. I built my own alfresco… 1 744 Is there a building permit? RU in Victoria? What is the value of the building contract? 1 7281 About a year ago, I embarked on a DIY project to construct an outdoor Pergola, which measures approximately 5.2 meters by 4.0… 0 30245 |