Good morning all,
I am usually tapping away on the keyboard about diy's for my car not my house!
but here goes.
I recently swapped over an internal sliding door for a new one.
Old one out no problems, swapped all fittings from old one onto new one.
Made sure the bolts were even to get the height of the door correct.
Now it slid well when putting it from the top of the door.
But when you you pull it from the handle the door seems to tilt up and not slide at all?
I mirrored everything on the original door but clearly I have made an error somewhere?
Can anyone help?
I look forward to much helpful info here as I have just started doing some diy's to my recently bought house.
Cheers