Browse Forums Renovation + Home Improvement 1 Nov 01, 2021 1:11 am Hi Guys, I am all finished with the house and living for last 2 months. However I realised that I need a side garage entrance door. In order to get the side entrance door, do I need to get a council approval ? If not, what are the possible thing that I should consider here. I have attached the engineering design and I cannot seem to find any support point , where the red mark is (where the door will go). Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Does that mean I just need to get a flat bar 110+cm for a 90+ wide door. I am thinking of putting this door: https://www.ebay.com.au/itm/203013280940 Thank you, amit Re: Garage Entrance Door 2Nov 01, 2021 10:04 am Hey Buildone Welcome to the forum Assuming you'll be placing structural lintels, then yes you will, best to give the council a call The problem with 2D footing plans is they don't always include details of other structural elements ie frames above here's a typical 3D Engineering Bim detail , though it will have to be checked with what has been built and certified Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Cheers Chris Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs The warning is on the sticker on the door too. Second the aluminium powdercoat 6 19116 Hi all, new to this forum. I need some advice me what is the process and how much it should cost me. The current door size is 820mm and I want to change it to a wider… 0 635 Dover white or surfmist garage door. I am having trouble choosing a garage door. The outside of house will be tranquel retreat. I want it to all blend nicely however I… 0 7375 |