Browse Forums Owner Builder Forum Re: DIY internal plastering 5Oct 17, 2014 8:04 pm Owner Building at Jimboomba Woods in Logan City Qld. Blog : http://bandlnewhomebuild.blogspot.com H1 thread : viewtopic.php?f=38&t=68283 . Re: DIY internal plastering 6Oct 17, 2014 8:09 pm Would definitely use a bagged render product. Shop round there's a few different ones available, the bigger paint suppliers have one as well as bunnings. Look on youtube for some tips, same as with plastering do a small wall until you get the hang of it. I'd even mix up a small amount, trowel it on and then scrape it back onto your hawk and put it back on again. Its a bit of a knack getting it from the hawk to the trowel and on the wall without dropping half of it but once you work it out its not too hard. If this is a custom build then I would expect the builder to set out the door frame closer to the wall to avoid the gap between architrave and the wall and or specify… 9 8301 Assuming the structure of your cabinetry is good then I would DIY everything as follows: - replace your counter tops entirely, - replace all drawer runners with soft close… 1 4782 |