Browse Forums Owner Builder Forum 1 Aug 01, 2011 10:42 am Can anyone recommend when it's best to install power points and switches? After painting and timber sanding but before polishing? Or at the very end, after polishing? Also, any comments on the order of things below? Primer & Ceiling paint -> Install timber floor -> Paint walls -> Sand timber floor -> Putty nail holes in timber floor -> Sand timber floor -> Polish timber floor Re: What's the correct order of doing things? 2Aug 02, 2011 11:00 pm Hi, From what I saw for my contruction, all paintings were completed before floor covering started. Good luck “It is good to have an end to journey toward; but it is the journey that matters, in the end” http://www.buildinganewhome.com.au I am new to this forum so please bear with me. An NCAT order was breach by our neighbour regarding a retaining wall dispute. He is the owner of a building company and he… 0 2208 The DIY project can be broken into two major steps. Planning and Design and Construction. Both of these steps are as important as one another to ensure you give… 0 5170 Hi group, have some damage to the door frame and skirting board. It's a side door to the laundry area. Only has a security door. I had a termite inspection (note drill… 0 5053 |