Aug 01, 2011 11:42 am
Can anyone recommend when it's best to install power points and switches? After painting and timber sanding but before polishing? Or at the very end, after polishing?
Also, any comments on the order of things below?
Primer & Ceiling paint -> Install timber floor -> Paint walls -> Sand timber floor -> Putty nail holes in timber floor -> Sand timber floor -> Polish timber floor
Re: What's the correct order of doing things?2
Aug 03, 2011 12:00 am
From what I saw for my contruction, all paintings were completed before floor covering started.
“It is good to have an end to journey toward; but it is the journey that matters, in the end”
Sign in or Join to reply to this Topic
Fore20Is the fence that has been recently put up correct?Is the fence that has been recently put up correct?
looks right! When the they build a zero boundry lot there is always around 180mm or 200mm gap. The little post (Yellow Arrow) should come out this much as that is to the…
SejaeDMetricon telling me I can't use CDC is this correct?Metricon telling me I can't use CDC is this correct?
I just had a look at the plans and it looks like Metricon have milked the standards as much as possible. The house is 473 sqm and they have managed to pull 85 sqm out,…
Claudia25Driveway flooding as it’s not level - is this the correct waDriveway flooding as it’s not level - is this the correct wa
Hi all, Coming to the end of a new build and thanks to the recent rain we’ve noticed the driveway doesnt drain properly (see first image). Spoke to builder and their…
MauromarioHeating/Cooling duct - correct installationHeating/Cooling duct - correct installation
The picture is not showing but id take a photo and send it off to VBA , i had problems with my ducted heating as well, when i called a plumber to come and fix it he told i…
bwenmanRestoring Correct Finish to a Patched Interior Brick WallRestoring Correct Finish to a Patched Interior Brick Wall
Sorry! I was asking in a more general sense as I do have larger holes to fill as well so your advice will be put to good use. We'll paint over it a few times with the…