Browse Forums Owner Builder Forum Re: Cladding a brick veneer house in fibre cement sheets 7Dec 28, 2009 4:49 pm mlads All I have is silver sarking between plaster and bricks no insulation so the R value would be low. Sounds like maybe getting the pumped-in insulation would be a more straightforward solution, though I admire you for trying to come up with an innovative and aesthetic solution. So how does one know when a weight is acceptable and when further advice should be sought? Clotheslines on walls are very common, but on the other hand there have been cases of walls collapsing from someone grabbing a little basketball hoop, and what about pergolas attached to the side of a house? We once got a quote for engineering advice (somewhat different matter) and I don't know if what we were quoted is a typical amount but it was rather a lot. DIY, Home Maintenance & Repair All my inside walls are Fibre Cement & House has Steel frames... Tricky when one wants to hang pictures or do Wainscoating Paneling up the hallway. Those little nail… 0 3152 Hi, Currently building, we are on a sloping block so we have from floor level to the roof in axon cladding. Below floor level to the ground I want to put brick facings /… 0 4480 2 8358 |