Browse Forums Home Theatre & Automation Re: Help: Drilling the Top plate for pre-wiring 6Jul 09, 2012 10:59 pm Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Help: Drilling the Top plate for pre-wiring 8Jul 10, 2012 9:49 am Paul you said, paulw11 should not run cables in the external wall cavity between the brick and the frame But all the power wiring to the switchboard is done this way isn't it? I spun a top noggin 90 deg so it was vertical to give me 25mm gap all the way between two studs during build. Did not compromise strength. Slab poured 21/04/2011 Frame finished 27/05/2011 Moved in 07/11/2011 I use Tramex moisture meter and it will tell me instantly if the wall is cement sheet or plaster or masonite but most people dont have the equipment. 5 7086 We've had the offer of a short term tenant whilst waiting for CDC/DA home approval and demolition for our knock down rebuild. It would achieve a pretty low rent as it's… 0 13758 The fastest thing a builder will do is bank your cheque, those systems work perfectly with lightning speed, everything else is slow burn. Just the way it is. 1 8707 |