Browse Forums Home Theatre & Automation Re: Recommend Melbourne/Vic store for bits and bobs? 4Mar 05, 2010 11:23 am ---------------------------------------- Building the PD Lisbon 24 http://www.porterdavis.com.au/#homeviewer/lisbon/24 Blog of our progress. http://lisbon24.blogspot.com/ Homeone build thread https://forum.homeone.com.au/viewtopic.php?f=31&t=28665 Re: Recommend Melbourne/Vic store for bits and bobs? 6Mar 06, 2010 7:20 pm Our house thread: https://forum.homeone.com.au/viewtopic.php?f=31&t=18335 Re: Recommend Melbourne/Vic store for bits and bobs? 7Mar 07, 2010 10:01 am Knockdown and rebuild - building Metr1con Nolan 41 (43) @ http://tim-and-tina.blogspot.com! http://www.verdantdental.com.au Re: Recommend Melbourne/Vic store for bits and bobs? 8Mar 07, 2010 2:03 pm slknv GSK I've used http://www.monoprice.com for all my cables in my hdmi setup (I use matrix setup and output to 5 different locations) I've saved a packet on there even though they're US based. Same, bought heaps of cables, wallplates, HDMIs, toslinks, components etc. Shipping was about $100USD for a massive box (arrived here in 4 days), but even with that included it was still heaps cheaper than anything locally. Also used monoprice about 3 years ago when wiring up my last house and all the components are great. Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ However, that said I didn't buy speaker cabling from monoprice because the increased weight increased the postage cost significantly so it worked out better buying speaker cabling locally in Melbourne. T&T Looks like all my cables. I feel like such a geek again but I love it! I just ordered my IR setup from www.a1components.com today. Cost less than $250AUD all up for the whole setup. I've had quotes as high as $1,000 here in Australia. I also ordered from Monoprice the recessed wall plates with power and section for the cables to go through (like what you have), I ordered some of them too where I didn't need the power to be recessed. My dads a sparky and I found in the Clipsal parts catalogue the change over power point for this unit which is for Aussie power connections. I think the total cost per unit was less than $30. P.S I love the USA for bits and pieces. Our house thread: https://forum.homeone.com.au/viewtopic.php?f=31&t=18335 I have a box of quality drill bits that seem to be new but their engraved sizes covered by rust ,,,,I tried to sand them to see their sizes but still I am finding… 0 1441 I have posted this before: We hired Darbecca to do every stage inspection, and I strongly recommend them to anyone that asks me. They were amazing. Thorough reports… 2 4518 It's all about wireless, self install now. The cost/benefit of wired setups for the house are no longer what they used to be. Lots of wireless options. Eufy, Arlo and… 2 9798 |