May 24, 2019 4:05 pm
I just had a double colorbond gate installed. Some cement were poured around the latches to act as an anchor because the latches do not reach the ground. This did not even last a day. The wind blew the gate open.
The gate was done at this height because of my concrete path around the house (which is about 15cm high) and I'm planning to add some soil or gravel to level the ground to the concrete pathway afterwards. Is there a better solution to hold the gates until the ground is levelled?
Sign in or Join to reply to this Topic
oldchippySide gate - dynabolt or chemset?Side gate - dynabolt or chemset?
10mm anchor screws will hold better in hollow bricks. Bore a hole half way through the post large enough to fit a socket. buy some 100mmx10mm anchor bolts so 50mm is in…
InvincibleInDNfront fence and gate installation before handover?front fence and gate installation before handover?
This is a question for your builder. Most of the builders don't allow the client to install/change anything before handover. You might get trouble in Interim or OC
meyeviewSliding driveway gate with Knotwood simulated wood slats ANDSliding driveway gate with Knotwood simulated wood slats AND
Hi, appears to be the only place where I can get a sliding driveway gate that uses knotwood simulated wood slats AND frame. But, I can't find any product reviews or…
LeeyBrick front fence and automatic sliding gate recomendation (Brick front fence and automatic sliding gate recomendation (
Hello, Can anybody recommend any contractor/company doing any brick front fence and automatic sliding gate in Sydney? Thanks in advance.