Building A New House
Apr 13, 2019 5:00 pm
I am currently building a house and they installed the cavity sliding doors. First of all these doors were installed and then they were removed as they installed the incorrect ones (As we ordered push to pull cavity doors)
They have removed and replaced, but have noticed big gaps between the cavity door and the house frame.
Does this look right to you?
Site supervisor says it is fine, but would like another opinion.
Re: Need Advice: Is this cavity sliding door installed corre2
Apr 14, 2019 8:46 am
That's the problem with replacing doors frame etc as the replacement may never fit properly.
In this case the constant opening and closing of the door may pull out the fixing nail and come loose
best to use packers and screws
Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs
https://plus.google.com/u/3/communities ... 1476023758
Re: Need Advice: Is this cavity sliding door installed corre3
Apr 14, 2019 8:00 pm
I just found the installation guide from the manufacturer that states packers should be used, so I will be organising a site meeting with the supervisor.
Thank you all for your feedback
Sign in or Join to reply to this Topic
PossumsBuilding with Eden Brae - Narrow Cavity Sliding DoorsBuilding with Eden Brae - Narrow Cavity Sliding Doors
Pictured is the 720mm CSD we had on the pantry of our last house. This door was only standard height - if you have 2340mm door height it will likely make it appear…
SejaeDSliding / Stacker door installation - Standard?Sliding / Stacker door installation - Standard?
What they can do without cutting the slab is to install the door over the step down and set it so the bottom is flush with height of your finished floor level ( say you…