Browse Forums Building A New House 1 Oct 02, 2017 7:41 pm Quick question how have you finished the bottom layer of bricks around your windows? Iv seen them on angles facing down or going straight accross I personally like them squared off can i just tell tbe bricks that how i want them or? Iv attached pics of what i mean Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Re: Bricking around windows 2Oct 03, 2017 8:12 am If you are an owner builder, yes you can. If not ask your builder's supervisor to instruct the bricklayer. There must be a slight slope out to shed water away from dwelling. Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Bricking around windows 4Oct 03, 2017 8:57 am Picture is fine Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog There is evidence of water on the head reveals. That could have happened during the build, or may be happening currently. There are water stains above a couple of windows… 2 3830 You’re on the right track, wire brush in a grinder then a zinc rich epoxy primer then a top coat of some sort, like a waterproofing membrane. Raising the concrete would… 1 7030 |