Browse Forums Building A New House Re: Our Lindeman 28 - Hand over end of may 121Jun 09, 2012 8:41 am Great kitchen. Beautiful photo that looks like home. Lovely. Re: Our Lindeman 28 - Hand over end of may 122Jun 14, 2012 10:03 am Looks amazing! Cant wait to see more pictures:) BTW: where did you find the home decor thing that is on your range hood? Love it. Forrestdale 27 Land Titled:4/11/11 Building Permit:4/11/11 Site Start Date: 16/11/11 Slab Date: 01/12/11 Frame Date:05/12/11 http://hordefamilyhome.blogspot.com/ Re: Our Lindeman 28 - Hand over end of may 123Jun 15, 2012 11:08 pm Well we have been in for a week as of yesterday and are absolutely loving it! We have achieved a fair bit since moving in and have a lot more still to do! The h o m e letters were a gift from Mtrcon at settlement so we have no idea where they got it! So far major stuff we have done: - paint entry feature wall and also tv feature wall - wall mounted 70" tv in lounge and 42" in bedroom Added power points and lighting (mate is a sparky) We have had our blinds installed and also all appliances are in. Every good story has a few problems. - Oven has made some weird clunking noise from day 1. They sent out a tech and he fixed it but he didn't so they are sending someone back out on Monday. - ensuite toilet bubbles when the shower is going. I would say the air vent has dirt in it or something so they will need to fix this once we can get a hold of maintenance! In the new few weeks we will have our decking done and meurbau gates up. The land scaping consultant is meeting us next week too. I will try and post up photos when I'm on the computer next. If there have been changes, variations, during construction then the drawings should be revised, the building permit amended and the current, as built drawings given to… 2 4481 I engaged my builder in December last year and we’ve been working on preliminary drawings for last couple of months. I got a call from the salesperson this morning… 0 552 Minimum overhang into gutter must be 50mm, turn down tool should not split the sheet. it seems wrong tool for the profile was used, the flashing cannot slope back. Rib… 2 2127 |