Browse Forums Building A New House Re: Has anyone used Dulux Mud Skipper Rendering on your faca 3Apr 08, 2010 10:27 am Not yet but I will be. I have seen the sample in the big book at the Dulux trade centre but i dont have a full scale pic to show you yet. Dulux doesnt do chips in either of my feature colours. In real life it is quite similar the colorbond Jasper. I had my Jasper sample with me when I went to the big book so I could compare. This is the pic I took of the colour in the big book. Still not totally accurate but it was darker than I thought it would be. http://i851.photobucket.com/albums/ab75/andy_min/30jun09099.jpg Min Building at The Ponds Land reg 3/12/09, Land settled 18/12/09 Approved by Design Panel 16/11/09, Submitted to council 24/11/09, Approved by Council 21/1/10 Site Start 21/5/10 http://andyminpondsbuild.blogspot.com/ https://forum.homeone.com.au/viewtopic.php?f=31&t=19800 Re: Has anyone used Dulux Mud Skipper Rendering on your faca 4Apr 08, 2010 11:04 am andy_min Not yet but I will be. I have seen the sample in the big book at the Dulux trade centre but i dont have a full scale pic to show you yet. Dulux doesnt do chips in either of my feature colours. In real life it is quite similar the colorbond Jasper. I had my Jasper sample with me when I went to the big book so I could compare. This is the pic I took of the colour in the big book. Still not totally accurate but it was darker than I thought it would be. Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Thanks Min Mud Skipper looks dark. Going to use it with Newport bricks with jasper windows, doors and garage door. Min Re: Has anyone used Dulux Mud Skipper Rendering on your faca 5Apr 08, 2010 2:59 pm http://forum.homeone.com.au/viewtopic.php?f=31&t=20360&hilit=mud+skipper&start=80 Page 5 there is a pic of Mud Skipper as a feature colour. I think its very nice. And this one as a render About 1/2 way down the page. http://professional-plastering-perth.com.au/pps/pages/textured-finishes-acratex-acrylic-rendering/acratex-colours.php Building at The Ponds Land reg 3/12/09, Land settled 18/12/09 Approved by Design Panel 16/11/09, Submitted to council 24/11/09, Approved by Council 21/1/10 Site Start 21/5/10 http://andyminpondsbuild.blogspot.com/ https://forum.homeone.com.au/viewtopic.php?f=31&t=19800 Dear Members I have to decide the Facade column size. My custom builder standard is 350mm with rendering, but i asked for 470mm plus stone or tiles and yet to get… 0 7508 Is it possible to render an old corrugated iron shed.I have heard that it can be done if it is covered with chicken wire first.Not sure of the ratio of the render mix and… 0 4899 yep you need a joint, foam is easiest, will look fine once rendered with a joint. 2 5243 |