Browse Forums Building A New House Re: Thermal bridging on a “Shed and Homes” kit house 3Nov 13, 2021 9:32 am Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re: Thermal bridging on a “Shed and Homes” kit house 5Nov 13, 2021 10:15 am Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re: Thermal bridging on a “Shed and Homes” kit house 6Nov 13, 2021 3:23 pm Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Thermal bridging on a “Shed and Homes” kit house 8Nov 14, 2021 9:37 am Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re: Thermal bridging on a “Shed and Homes” kit house 9Nov 14, 2021 7:41 pm Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Thermal bridging on a “Shed and Homes” kit house 13Nov 14, 2021 10:39 pm Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re: Thermal bridging on a “Shed and Homes” kit house 14Nov 15, 2021 7:57 am Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Thermal bridging on a “Shed and Homes” kit house 16Nov 15, 2021 9:36 am Designer,Engineer (Civil,Const & Envir),Builder,Concrete & Masonry Contract.Struct Repairs Re: Thermal bridging on a “Shed and Homes” kit house 18Nov 15, 2021 7:54 pm They have suggested to put 20 mil thick timber batons on the internal frame so the Gyprock screws into it to create the thermal break, but now I am combating the heat at the Gyprock end rather than before the frames at the colourbond end so internal frames will be hot I’m not sure if that will make my house too hot even with good insulation fitted Is it possible to render an old corrugated iron shed.I have heard that it can be done if it is covered with chicken wire first.Not sure of the ratio of the render mix and… 0 4896 Thanks. Yeh ideally that would have been good, but have progressed too far now. Hoping some well placed internal walls fixed up into the battens will provide some… 2 5404 Hi, I am sheeting the inside of a 5.7 x 8m shed with gyprock. Unfortunately the shed wasn't designed for internal cladding but I have been framing it up as strongly as… 0 3423 |