Browse Forums Building Standards; Getting It Right! Re: MATRIX Cladding wall edge 4Aug 17, 2016 9:12 pm jsm009 Yes that is one way that the matrix can be finished off as it becomes an explanation joint between the masonry and the cladding and as long as the flashings are done correctly from the top down it should be okay the other way would be to butt the matrix up to a length of moulding that is against the brick Thanks JSM....sets my mind at ease Hi, Currently building, we are on a sloping block so we have from floor level to the roof in axon cladding. Below floor level to the ground I want to put brick facings /… 0 4494 Hello everyone, After some suggestions and ideas about how to put a concrete path around the drop edge beam area on our new build. We are required to have a concrete path… 0 12875 |