Building Standards; Getting It Right!
Re: Eave board vibrates/ makes noise in high wind3
Aug 29, 2010 11:50 am
If it's on a brick veneer construction with the eave sheet sitting on the brick then it could be at that point due to lack of fixing to trimmers.
In any case it sounds like it may be due to insufficient nailing to trimmers - which I would deem as unacceptable.
Peter Clarkson - AusDesign Australia
This information is intended to provide general information only.
It does not purport to be a comprehensive advice.
Sign in or Join to reply to this Topic
jazig_kUnder eave bare ground and alfresco finishing design/textureUnder eave bare ground and alfresco finishing design/texture
Hi everyone. Slowly chipping away at the landscaping around our new place and finishing off around the immediate house and alfresco. Grass seed has taken well for how…
JokerWhat makes for "expensive" engineering for new home?What makes for "expensive" engineering for new home?
Just remember when you minimize engineering needs, slabs etc, such has the Kings of minimizing engineering, slabs, most volume boys, you leave no room for error,…
Falmer5R ratings and their impact on heat and noise insulationR ratings and their impact on heat and noise insulation
Greetings from Taiwan! I am currently renovating an old apartment in Taipei. Part of this involve building up walls, and insulating a ceiling. Unfortunately there is very…