Browse Forums Building Standards; Getting It Right! Re: Builder insisted that this is acceptable 21Aug 23, 2009 4:34 pm Building with Homebuyers Centre El Questro! My building thread..viewtopic.php?f=31&t=19421 Brickies started 5/10 Re: Builder insisted that this is acceptable 36Jan 06, 2010 8:38 am Stefan Building the M3tr!con Liberty 42 at Stonecutters Ridge. The New Build Blog - "Life, In Progress." Stonecutters Ridge Community Website | My photos Re: Builder insisted that this is acceptable 38Jan 06, 2010 5:05 pm Distortion of doors (as per Standards & Tolerances) Door eaves are defective if, during the first 3 months they twist or bend greater than the limits listed below. Twisting: measured diagonally across door [b]Limit 5mm[/b] Bending in door heights up to 2150mm high limit 4mm Bending in door heights between 2150 & 2400mm high Limit 6mm Bending in door heights over 2400mm high Limit 7mm Bending in door widths up to 1020mm wide Limit 2mm Surface (face) misalignment, at the meeting egdes of double swing or French doors, when the doors are fully closed Limit 5mm hope this helps Dirk 1 4581 1 13125 I wanted to get some thoughts on the quality of workmanship on the following brickwork? are there specific clauses in Australian Standards which relate… 0 4798 |