Browse Forums Windows & Doors Re: Hole left open at windows bottom 13Mar 20, 2019 11:21 am JoePathan Is there an Australian standard code which I can quote to the builder for missing sill flap and short sill flap? This is an easy one... all windows are type tested to meet AS2047... this covers water resistance and wind resistance. Your windows will have been tested this way, and as such should be supplied as tested. And also installed as supplied. These windows would not pass test as they are... they have to be fixed. "ECOECO" At 'EcoEco', we design windows, we design the best windows, we do it for you, so that when you’re happy we are happy. Tel. 1800 326 326 you need a fridgie to answer but I would think you vac the whole system then add gas if you have a leak, unless it is new install with the gas already loaded, in that case… 1 3664 Old Home Restoration / Renovation Hi, just discovered all these junks left behind under the floor. Could any of these be asbestos? Best to leave as it is or clean up? Thank you for your thoughts 0 8070 can’t tell from the photo, a tie down rod will be 12mm, is it a steel beam? he should be able to work it out 1 4470 |