Browse Forums Paving & Concreting 1 Mar 10, 2016 9:48 pm Hello, We recently purchased some pavers made by E PAVE Engineered Stone Solutions (600x600x18mm paver). The retailer we have purchased them from advised they would be fine being laid on a crushed rock / sand base (for foot traffic only) despite the following articles provided by other retailers. www.stonehub.com.au website - http://www.stonehub.com.au/wp-content/t ... ELINES.pdf www.ppmstone.com.au website - http://www.ppmstone.com.au/wp-content/u ... m_.au_.pdf I have already prepared the base to the following specifications: Compacted 100 mm crushed rock base Compacted 25-35 mm of packing sand (as we are unable to compact once the paver is laid due to the thin profile) Spaced at 3mm Filling in the joints with ATA Aus-Grout Sealing the pavers Wondering if anyone had any suggestions? Cheers, Pete Render your bathroom walls, two opinions versus the one, makes you wonder. 3 4203 thanks Chippy, i hope they have applied sealer but i am doubt to be honest, so i am gonna do this job after handover. 8 11923 I am building in claymore NSW and this is shown in the building envelope plan. … 0 4997 |