Browse Forums Paving & Concreting 1 Dec 01, 2011 6:27 am Hi all, I'm planning on placing a concrete path around the perimeter of part of my house. The area to be concreted is bordered using a (motered in place) brick border with sections of approx. 3m x 1-1.2m My questions are; Should I dowel between the house slab and the new path? There will be foam between house slab and new path. Should I dowel between the each section? Regards, D Re: Dowel Joints in Concrete Path 2Dec 01, 2011 10:44 am Have a read of the following document its got loads of good information http://www.concrete.net.au/publications ... veways.pdf The Harder You Try - the Luckier You Get ! Web site http://www.anewhouse.com.au Informative, Amusing, and Opinionated Blog - Over 600 posts on all aspects of building a new house. Hi All, First time poster. I was hoping to get some advice on villaboard installation within a bathroom. I have installed villaboard before, in a laundry. I think I did… 0 7454 Hello everyone, After some suggestions and ideas about how to put a concrete path around the drop edge beam area on our new build. We are required to have a concrete path… 0 12867 Thank you so much for your response. I have drawn a pedestrian gate in - for curb appeal, let's see how much costs come in at. I think you're right - if we decide to… 2 6517 |