Browse Forums Paving & Concreting Re: Sandstone pavers as retaining wall cladding 4Sep 23, 2011 12:49 pm baldy I made a water wall, over 1m high and used Sikaflex construction adhesive for the cladding. Can't remember which one, just go and read the different tubes at Bunnings. Works brilliantly and is not hard like mortar, it retains a certain amount of flexibility. Just apply 5 big blobs on the tile and squeeze onto the wall. May need to prop it up depending on how heavy the tile is, until dry. Cheers Hi baldy can you post a picture of your water wall ...we are also planning to to do one Thanks, saritha I had 28m2 of engineered pavers laid six months back and it was difficult to find someone not taking the pi$$. Internet suggested it should be $85-100/m2 to lay them.… 3 12378 Thank you again Simeon.. I will call my certifier for that. Have a good day 4 5179 Hi, Currently building, we are on a sloping block so we have from floor level to the roof in axon cladding. Below floor level to the ground I want to put brick facings /… 0 4478 |