Hi everyone.
This is actually a kitchen tap but this seemed like the best place to ask.
I have a dripping single lever mixer tap, so thought I would change the cartridge.
I went through the usual steps, turned off water, removed grubscrew, removed handle, removed collar.
I was expecting to see the exposed cartridge and locking nut, and expecting to unscrew locking nut and replace cartridge.
However when I removed the collar what I found was what is shown in the attached pic, so I'm not sure how to proceed. I can't see any locking nut to remove, only some screws that I am not confident to undo.
If anyone can give me a next step here it would be appreciated.
Thanks
Farness Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅