Dec 09, 2017 2:24 pm
I made the mistake of putting in a very narrow bath. with the shower screen on the inside of the lip, there is barely enough space on either side of your shoulders – bad mistake.
I don't want to rip out the bath, but would like to move the screen out. Here is my idea, but am unsure of how to fill the area between the lip and the glass. There needs to be a channel so the water off the screen goes back into the bath and does not puddle between the bath lip and the glass.
here's a bigger pic of the bathroom, for context
1. a piece of timber (waterproofed) that the glass would sit on, timber molded so there is an angle for the water to drain back into the bath. pretty cost effective.
2. piece of stone – similar to the timber, prolly alot more expensive
3. a little tiled hob on top of the existing hop. might look a little odd as the other tiles are 300x600 around the bathroom
any other suggestions or comments?
move the screen out to give more shoulder and elbow room, it's tight!
Sign in or Join to reply to this Topic
StructuralBIMGuyReplacing standard shower head with a double shower headReplacing standard shower head with a double shower head
I would do the same.. doubt i would need a plumber to swap over a simple shower head OT, As many battlers & punters on this forum are aware after entering Contracts…
aussietaMoving in with no concrete paths/drivewayMoving in with no concrete paths/driveway
we moved in without paving after the first winter, my wifes car was slipping around so much it ended up under the verandah could not get a concreter to even quote 6.5m x…