I tried painting my bathtub with Rust-Oleum Tub & Tile Refinishing Kit from Masters. It was a disaster. I took a hammer at the tub. Now it's gone:
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
I am trying to put in a new tub like this: https://www.masters.com.au/product/900009136/sonata-inset-bath-tub-1505mm - dimensions are identical to previous tub.
Problem is stupid drain pipe has nut that has to be tightened from bottom:
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Obviously, once I lower new tub into same location, I can no longer get to the nut! Unless I break down brickwork of course... even then it's hard.
I have seen American YouTube videos where drain wastes have been unscrewed from the top, but seems system used in Australia is different with nut below the tub.
Anyone done this or any advise about what I should do!?