Browse Forums Bathrooms and Laundry 1 Jul 26, 2013 5:52 pm We were thinking of using porcelain tiles for the floor and bath/shower walls and then ceramic (as they're cheaper) for the remainder of the walls - both in a 300 x 600 size. Are there any issues with how they might look in terms of matching up the grout lines? i.e. is it better for uniformity to either use all porcelain or all ceramic? Thanks Re: Mixing porcelain and ceramic tiles 2Jul 26, 2013 7:46 pm If you use rectified edged ceramic tiles it should be ok. You may have issues with matching the grout of different tiles even if they are 300x600 nominal (porcelain or ceramic). How much extra is all porcelain going to cost? Re: Mixing porcelain and ceramic tiles 3Jul 29, 2013 8:30 pm I used both in my ensuite and it looks fine, we did use rectified tiles. Firstly the ableflex that has been installed needs (manufactures specification) a sealant cap over the top, preventing water draining down between the slab and the… 3 7744 Our house was completed 8 years ago. Builder did not leave any spare roof tiles behind. Just found out that one tile is cracked. Wanted to replace the tile but most… 0 2774 1 15729 |