Hey all
Currently renovating our laundry, bought a new washing machine but have found that the drainage hose is alot shorter than the old machine (which I used to get the placements of everything beforehand)
Have bought an extension kit... but now it's WAY too long. I see that I would have three issues but I'm not sure the best way to go
1 - just connect it and loop the new hose
2 - cut the new hose and super glue the rubberised end back on the shorter length
3 - remove the original hose (not sure how exactly on a Fisher and Paykel as I think it requires removing the entire back of the machine, which I'm already stacked with the dryer so would prefer not to)
Any suggestions? My concerns are that if I just loop the hose, it will cause stagnant water to collect but also if I cut the new hose, I won't actually be able to glue the rubber end back on
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
WatchingStarredHistory
MembersPros
Browse Forums Bathrooms and Laundry I am looking to install a new garden hose external to a blockwork house. There is existing water service on the interior opposite the proposed location so looking at… 0 18126 Building Standards; Getting It Right! When my house was built (over 7 years ago), the post brackets were done to allow for concrete porch, but they didn’t allow for the planned stone paving. I’m finally… 0 22063 Hi All, I'm planning on doing a minor renovation to my apartment in the City of Sydney. The apartment has an unusual multi-level layout with a large void over the living… 0 19759 |
