Oct 06, 2019 3:01 pm
So my builder installed 6 ceiling fans in total in my new home. For all of them, the wall control has 1 dot being the strongest and 3 dots being the weakest.
I questioned them and they say that's how it's supposed to be because it's more efficient to start the fan at the highest power and that's what people usually do. I can agree with that but shouldn't the dots represent the power? It's so confusing...
Sign in or Join to reply to this Topic
building-expertWrong bracing used, can other side of stud wall be braced coWrong bracing used, can other side of stud wall be braced co
Yes you can brace the other side of the stud wall
MasheeWall and Ceiling InsulationWall and Ceiling Insulation
For that R-value, they should install batts (or similar). However, they do that just before or while the plaster board goes on, otherwise, the insulation will just fall…
TumiRepainting Bathroom Ceiling and WallRepainting Bathroom Ceiling and Wall
Hi. There was mould all over the bathroom ceiling and wall and j took it upon myself myself to remove all the paint and repaint the whole wall and ceiling. I have removed…
thepa1nterRepairing wall & ceiling join.Repairing wall & ceiling join.
Open the paper gap up a little so you can squirt water-based liquid nails in there, wipe clean with baby wipes or a damp rag. Paint the next day, it will never move. Make…
Mr. SausageWall switch - ceiling fan speed and timerWall switch - ceiling fan speed and timer
Hi, I have a ceiling mounted fan and currently there is just a wall switch with a rotary dial (off and then three speeds). Is there a way to have a timer / speed switch…