Browse Forums Heating, Cooling & Insulation Re: The Brivis Networker Wall Control 3Jan 04, 2019 8:17 am Assuming here you have evap cooling and gas heating, to switch it needs to be able to talk to both units. So my suggestion is to power off the heater and cooler at the same time, wait 20 seconds or so and turn on. If you still cannot switch then I would suggest one of the units is faulty. To my understanding early saw cuts are to control shrinkage cracks, so doing them now would be pointless. Control joints may reduce ugly cracking during periods of soil… 3 9863 Hi group, have some damage to the door frame and skirting board. It's a side door to the laundry area. Only has a security door. I had a termite inspection (note drill… 0 5059 Hi All, First time poster. I was hoping to get some advice on villaboard installation within a bathroom. I have installed villaboard before, in a laundry. I think I did… 0 7471 |