Browse Forums Heating, Cooling & Insulation 1 Jul 20, 2013 5:52 pm This question has probably been asked before but ............... We have just installed a Regency free standing Gas Log fire (natural gas) Fan kicks in after 5 minutes or so. Flame goes OK for awhile then cuts out. Pilot is still going. Then the flame will kick in again - after 10 to 20 minutes. Is this normal? Have never had anything to do with gas in the past so just being a bit cautious (and there is nothing in the manual about this happening) Cheers Re: Flames going out on Gas Log heater 3Jul 20, 2013 10:43 pm The room gets to set temperature so off it goes. Drops a degree or two and kicks back in. So almost certainly nothing is wrong. Next time it cuts out, up the temperature setting a few degrees and see if it lights back up. 4 Beta DIY, Home Maintenance & Repair Hi everyone Question about Brevis gas heating undergound - was recently installed by previous owners (<1 year old) but live in a relatively large house - 4 bdr - and only… 0 1641 DIY, Home Maintenance & Repair Hi, I have an old fence/barrier made of treated pine logs bolted to plates and these are bolted to very large metal posts/girders. The plates and bolts are rusted through… 0 15118 0 1341 |