Browse Forums Heating, Cooling & Insulation 1 Jul 04, 2011 3:06 pm Hi, There was an oversight in the contract in regards to in-slab heating. About 25sqm needs to be installed next Monday, before the concrete goes down. I spent the weekend sending off requests for quotes, but frankly, this job sounds remarkably easy: unroll the cable, clip it to the rebar, install the temperature sensor, and cap it off where it rises near the wall. I plan to integrate it with a homebrew LinuxMCE system so only a fairly basic DIN-mounted controller will be needed. There are a few online suppliers of in-slab cable kits, do you reckon it's a pretty easy job to do oneself? Newtown rebuild: https://forum.homeone.com.au/viewtopic.php?f=53&t=48977 Hi guys, I want to do some floor levelling before laying the planks and am considering doing it with self-levelling or yellow tongue PB board. I am wondering which one… 0 3932 Hi everyone! This is my first time posting here, and I'm looking for some advice regarding my house construction project in North Kellyville. I… 0 4697 Hi all. I'm thinking of installing an electric gate in front of this street front villa (link below). The gate would be between the bush on the left and the letter box on… 0 1768 |