Browse Forums Heating, Cooling & Insulation Re: How to restart Brivis Wall Control with FN Key 2May 04, 2009 10:43 am Gav & Vanessa Building In Melbourne (Sth East Suburbs) http://www.arkraider.blogspot.com/ Rawdon Hill Construction - Canterbury Heritage Re: How to restart Brivis Wall Control with FN Key 4May 04, 2009 10:48 am Gav & Vanessa Building In Melbourne (Sth East Suburbs) http://www.arkraider.blogspot.com/ Rawdon Hill Construction - Canterbury Heritage Re: How to restart Brivis Wall Control with FN Key 5May 04, 2009 10:54 am Gav & Vanessa Building In Melbourne (Sth East Suburbs) http://www.arkraider.blogspot.com/ Rawdon Hill Construction - Canterbury Heritage Re: How to restart Brivis Wall Control with FN Key 13Jun 03, 2021 11:29 pm I too had a blank screen with 8 dots. None of the suggestions to restart in the manual worked. I went outside, turned off the 240 V switch briefly that powers the heating unit and turned it back on. Went inside and bingo, the controller had sprung to life with all the usual settings. Your house should come in "as new" condition. It should be clean, and without stains 1 4774 Hi group, have some damage to the door frame and skirting board. It's a side door to the laundry area. Only has a security door. I had a termite inspection (note drill… 0 5141 Hi All, First time poster. I was hoping to get some advice on villaboard installation within a bathroom. I have installed villaboard before, in a laundry. I think I did… 0 7577 |